The rise in energy costs is most likely going to remain in the foreseeable future. Moreover, the transition to renewable energy is going to demand a lot of time and expenses. The efficient cleaning of heat exchangers decreases energy costs […]
Author: Firma mycon
Manual or automated cleaning of tube bundle heat exchangers and separate tubes through TubeMaster.
Posted on Posted in General
mycon GmbH developed its purification process TubeMaster a long time ago. TubeMaster cleans small tubes with a diameter of approximately 50 mm, when using a special version even tubes with a diameter of 100 mm. This purification process even achieves […]
TubeMaster AS in operation
Posted on Posted in General
Cleaning attempts using extreme pressure cleaning with water of 2500 bar were unsuccessful – TubeMaster AS, however, was able to get the job done. The patented cleaning method TubeMaster AS was able to successfully clean tubes of 8 meters of […]
Body repair made easy with SplitMaster
Posted on Posted in General
SplitMaster – the newest mycon device is used to partially cool components as an open or closed system. During long-term-use the operating materials can be completely processed so that they can be reused. SplitMaster cools down surfaces to temperatures as […]
mycon GmbH – operation near to zero waste
Posted on Posted in General
SplitMaster – the newest mycon device is used to partially cool components as an open or closed system. During long-term-use the operating materials can be completely processed so that they can be reused. SplitMaster cools down surfaces to temperatures as […]
Climate change is a focal issue at mycon
Posted on Posted in General
It is no longer possible to stop climate change through technical improvements alone. But even small steps towards increasing efficiency in the generation of energy and towards saving energy can slow down the pace of climate change so that the […]
A global problem: Non-destructive separation of bonded connections
Posted on Posted in General
Bonded areas can be released by super-heating surfaces to 350-400°C. The bonded areas must be heated to at least 150°C in the process. However, applying such high temperatures can damage the materials / adjacent bonded layers. Subsequent testing, for instance […]
Optimal cleaning service for heat exchangers, based on digital monitoring
Posted on Posted in General
Normally, large-surface cooling systems such as air condensers used in energy production, are cleaned 1-3 times per year. Most of the time, cleaning is semi-automated; a motor moves the nozzles vertically, while the ladders of the cleaning system are moved […]
Efficient, quick, energy saving – the new cooling method by mycon SplitMaster offers new opportunities
Posted on Posted in General
SplitMaster cools down surface areas quickly and efficiently to temperatures up to -70°. The cooling process can only occur partially. Quickly achievable cryogenic temperatures offer a lot of advantages for processes like the cleaning of contaminated surfaces, as well as […]
Save energy, conserve water resources, reduce maintenance costs with JetMaster and JetBoy/JetBoy SP
Posted on Posted in General
Fouling on finned heat exchangers forces the rotors to run at higher speeds to maintain the required temperatures. As a result, they require considerably more electrical energy. If the fouling is too severe, the rotors cannot provide sufficient air exchange […]